MB5 biocide for cosmetics

MB5 biocide for cosmetics

Mixture formular of MIT and BIT

Our factory launch the MB 5 biocide, whichis is an aqueous solution of BIT (1,2-Benzisothiazolin-3-one) and MIT(2-Methyl-4-isothiazolin-3-one) at a ratio of 1:1; The MB 5 biocide combines the well proven active ingredients BIT and MIT which can provide a long-term and broad efficacy spectrum, widely used for the in-can preservation of technical products. MB 5 biocide is a VOC- and AOX-free preparation. It is formulated without the addition of any organic solvents, halogenated organic compounds, formaldehyde releasing compounds or bivalent metal ions, and therefore, it is highly compatible in most binder and paint systems.

Miscibility/Solubility

Miscible with water and most low alcohols, glycols and glycol ethers, clearly soluble in water at ready to use concentrations.

Feature of MB5

1) MB5 is a new generation of synergistic type without CIT (5-chloro-2-methyl-4-isothiazolin-3-one), AOX (adsorbable organic halide) and VOC (organic volatile matter) Fungicide.

2) Do not add any organic solvents, halogenated organic compounds, formaldehyde releasers or divalent metal ions.

3) Easily soluble in water, most lower alcohols and glycols.

4) Wide applicable pH range, can be used in the range of 2.0 ~ 10.0

5) It has a very broad-spectrum bactericidal activity against bacteria, molds and yeasts that cause pollution and degradation of aqueous products.

Usage and precautions:

1) It is recommended to use a concentration of 0.2-0.4%. Select the appropriate dosage according to the product used and the environmental conditions.

2) It should be noted that the temperature, pH value and redox potential during addition will not affect the stability of this product.

3) Store in the original container. Avoid extreme temperatures. Frost easily, BIT and BIT sodium salt may crystallize when the temperature is lower than 1℃; However, if it is heated to a maximum of 50℃, any crystals formed will dissolve again without affecting the performance.

Application

MB 5 can be used to protect latex paints, polymer emulsions, adhesives, enamels, fillers, sealants and other water-based products from harmful microorganisms when they are wet, especially suitable for products with higher pH values and environmentally friendly formulas.